Instructions for Use
Table Of Contents
- Content
- [Customer]
- [Instructions for use]
- [Installation]
- 1.Installation Steps
- 1>How to find the power cord of the car ?
- 2>How to find the ground wire of the car (negative
- 3>How to find the horn line of the car?
- 4>How to test whether the unit work properly?
- 5>How to connect Bluetooth?
- 6>How to fix the unit ?
- 7>How to install the navigation antenna ?
- 8>The default factory mode password
- 9>The default Bluetooth Pin Code
- 2.Schematic diagram of reversing camera wiring
- 3.Fixed machine
- 1.Installation Steps
- [Introduction to basic functions]
- [Simple Trouble shooting]
- 1>Unable to boot normally
- 2> Automatic shut-down
- 3> Having noise
- 4> Remote control cannot be used
- 5> Settings con not be saved (no memory)
- 6> Car audio with Bluetooth but if can't work
- 7>The product smoke has proved that the internal c
- 8>How to adjust the sound, where is the equalizer
- 9>Support no image of reversing camera
- 10> USB flash disk can not be played, the card wit
- 11> FM does not receive the program
- 12>How to install
- 13>How to remove the original car's radio
- 14>Install it without reading the card or USB flas
- 15> Just installed no sound
- 16> After a while there is no sound
- 17>Machine reset
- 18>The other party cannot hear the voice of the Bl
- 19>The clock is still displayed after the product
46
find a screwdriver or a metal strip to insert it instead of the antenna.
12>How to install
This depends on your personal hands-on skill. Most people can install it
themselves. That is so good. No worry about it, I will tell you how to do it.
[Installation method]: Remove the original car radio, the new unit can be
installed back according to the installation method of the original car radio
(that is, how the original car unit is installed, you will install it back, you will
do).
13>How to remove the original car's radio
The best way is to do it yourself. If it doesn't, you can ask the installer to
help you.
14>Install it without reading the card or USB flash disk
- Before the unit is shipped, it is tested that the USB flash disk and the
card are not read. Do not easily suspect the unit.
First format that card or USB flash on the computer and download again,
then try again. If not, please change your card or USB flash disk to try it. If
you still can't, please unplug the unit and plug it in again. If you don't read it,
it may be a unit problem, return to the new or after-sales.
15> Just installed no sound
- Dear customers, the unit has been tested before shipment. If there is
no sound, it is usually a wiring error or the original car speaker wire is short-
circuited with iron. Please do not doubt the unit. According to the steps to
check it,
1.Check whether the speaker cable is short-circuited and connected. If
there is a short circuit, please reconnect it.
2.Check how many speaker cables according to the original speaker
cable if there are only 2 speaker cables to prove that the original car line
does not match our unit, you need to re-route the original car line. One
speaker must lead to 2 speaker wires. 2 speakers must be have 4 speaker
cables to available.