Installation Guide

SHOWERHEAD INSTALLATION INSTRUCTIONS

INSTALL BY HAND

Note: Some shower arms are formed with a ball where the head connects. We suggest that you either replace

this type of arm or use an adapter, which can be found at a hardware store, plumbing or home center.

**10 YEAR WARRANTY: AM Conservation Group warranties to the original purchaser of this product that it is free from defects in material

and workmanship for a period of ten years. AM Conservation Group will at our choice replace any part of the product which is in our opinion

defective provided that the product has not been abused, misused, altered, or damaged after its purchase. This includes damage due to

the use of tools or harsh chemicals. In the event a product has been discontinued, AM Conservation Group will replace it with what we

determine to be the closest product. AM Conservation Group is not responsible for labor charges, installation, or other consequential cost.

AM Conservation Group’s responsibility shall not exceed the original cost of the product. Save your receipt as proof of purchase is required

for warranty action.

2301 Charleston Regional Parkway | Charleston, SC 29492 | Customer Service: 1.888.866.1624 | www.amconservationgroup.com

1 Remove the old showerhead from the shower arm by turning it counter-clockwise.

2 Before installing the new showerhead, clean the shower arm threads, then turn on the water to wash out the pipe.

3 TURN OFF WATER.

4 Apply a few layers of plumber’s tape directly to the shower arm threads in a clockwise direction to create a watertight seal.

5 Check that the screen washer is seated rmly into the showerhead before tightening.

6 Hand tighten the showerhead onto the shower arm. DO NOT OVERTIGHTEN.

To clean: unscrew showerhead and remove foreign particles. Soak nozzle in hydrogen peroxide or vinegar.

PAGE 1
SHOWERHEAD INSTALLATION INSTRUCTIONS INSTALL BY HAND Note: Some shower arms are formed with a ball where the head connects. We suggest that you either replace this type of arm or use an adapter, which can be found at a hardware store, plumbing or home center. 1 Remove the old showerhead from the shower arm by turning it counter-clockwise. 2 Before installing the new showerhead, clean the shower arm threads, then turn on the water to wash out the pipe. 3 TURN OFF WATER.
PAGE 2
INSTRUCCIONES PARA INSTALAR EL CABEZAL DE DUCHA INSTALAR CON LA MANO Nota: Algunos brazos de ducha tienen una esfera en donde se conecta en cabezal. Sugerimos que reemplaces este tipo de brazo o uses un adaptador, que puedes encontrar en una ferretería o en una tienda de artículos de plomería o del hogar 1. Retire el viejo cabezal del brazo de la ducha dándole vueltas en sentido contrario a las manecillas del reloj. 2.