Installation Guide

DUAL THREAD AERATOR INSTRUCTIONS - INSTALL BY HAND

2301 Charleston Regional Parkway

Charleston, SC 29492

Customer Service: 1.888.866.1624

www.amconservationgroup.com

Offering products by

(1) Remove old aerator from faucet. Pliers may be required. Use cloth to

protectﬁnish.(2) Before installing new aerator, turn on water to wash out

faucet. Turn off water.

If the faucet has internal threads:

(1) Check aerator assembly to assure proper setup. The setup should be

as follows: a thin rubber washer should be inside of the aerator, then a

thick rubber washer on top. (2) Screw aerator assembly onto faucet.

(hand tighten)

If the faucet has external threads:

(1) Remove thick upper washer. (2) With thin washer in top of aerator,

screw aerator onto faucet. (hand tighten)

Note: Remove aerator and rinse parts occasionally.

**10 YEAR WARRANTY: AM Conservation Group warranties to the original purchaser of this

product that it is free from defects in material and workmanship for a period of ten years. AM

Conservation Group will at our choice replace any part of the product which is in our opinion

defective provided that the product has not been abused, misused, altered, or damaged

after its purchase. This includes damage due to the use of tools or harsh chemicals. In the

event a product has been discontinued, AM Conservation Group will replace it with what we

determine to be the closest product. AM Conservation Group is not responsible for labor

charges, installation, or other consequential cost. AM Conservation Group’s responsibility

shall not exceed the original cost of the product. Save your receipt as proof of purchase is

required for warranty action.

PAGE 1
DUAL THREAD AERATOR INSTRUCTIONS - INSTALL BY HAND (1) Remove old aerator from faucet. Pliers may be required. Use cloth to protect ﬁnish. (2) Before installing new aerator, turn on water to wash out faucet. Turn off water. If the faucet has internal threads: (1) Check aerator assembly to assure proper setup. The setup should be as follows: a thin rubber washer should be inside of the aerator, then a thick rubber washer on top. (2) Screw aerator assembly onto faucet.
PAGE 2
INSTRUCCIONES DE INSTALACIÓN DE AIREADOR DE ROSCA DUAL – INSTALAR CON LA MANO (1) Quite el aireador antiguo del grifo. Puede que necesite usar un alicate. Use un paño para proteger el acabado. (2) Antes de instalar el aireador nuevo, abra el agua para lavar el grifo. Cierre el agua. Si el grifo tiene rosca interna: (1) Revise el ensamblaje del aireador para garantizar que la configuración sea adecuada.