Instructions / Assembly

HANDHELD SHOWERHEAD INSTALLATION

INSTRUCTIONS

INSTALL BY HAND

Note: Some shower arms are formed with a ball where the head connects. We suggest

that you either replace this type of arm or use an adapter, which can be found at a

hardware store, plumbing or home center.

1. Remove the old showerhead from the shower arm by

turning it counter-clockwise.

2. Before installing the new showerhead, clean the shower arm

threads, then turn on the water to wash out the pipe.

3. TURN OFF WATER.

4. Apply a few layers of plumber’s tape directly to the

shower arm threads in a clockwise direction to create

a watertight seal.

5. Check that there is a screen washer seated in the bracket.

Attach the bracket to the shower arm.

6. Place a rubber washer into one of the ends of the hose

and then connect the hose to the bottom of the bracket by

turning it by hand, clockwise to the arm.

7. Place one rubber washer into the other end of the hose and

then attach it to the showerhead wand.

8. Tighten all ttings until it is snug. DO NOT OVERTIGHTEN.

To clean – unscrew showerhead and remove foreign particles.

Soak nozzle in hydrogen peroxide or vinegar.

** 10 YEAR WARRANTY: AM Conservation Group warranties to the original purchaser of this product that it is free from

defects in material and workmanship for a period of ten years. AM Conservation Group will at our choice replace any

part of the product which is in our opinion defective provided that the product has not been abused, misused, altered,

or damaged after its purchase. This includes damage due to the use of tools or harsh chemicals. In the event a product

has been discontinued, AM Conservation Group will replace it with what we determine to be the closest product. AM

Conservation Group is not responsible for labor charges, installation, or other consequential cost. AM Conservation

Group’s responsibility shall not exceed the original cost of the product. Save your receipt as proof of purchase is

required for warranty action.

2301 Charleston Regional Parkway | Charleston, SC 29492 | Customer Service: 1.888.866.1624 | www.amconservationgroup.com

PAGE 1
HANDHELD SHOWERHEAD INSTALLATION INSTRUCTIONS INSTALL BY HAND Note: Some shower arms are formed with a ball where the head connects. We suggest that you either replace this type of arm or use an adapter, which can be found at a hardware store, plumbing or home center. 1. Remove the old showerhead from the shower arm by turning it counter-clockwise. 2. Before installing the new showerhead, clean the shower arm threads, then turn on the water to wash out the pipe. 1 6 2 3. TURN OFF WATER. 4.
PAGE 2
INSTRUCCIONES PARA LA INSTALACIÓN DEL CABEZAL DE DUCHA MANUAL INSTALAR CON LA MANO Nota: Algunos brazos de ducha tienen una esfera en donde se conecta el cabezal. Sugerimos que reemplaces este tipo de brazo o uses un adaptador, que puedes encontrar en una ferretería o en una tienda de artículos de plomería o del hogar. 1. Retire el viejo cabezal del brazo de la ducha dándole vueltas en sentido contrario a las manecillas del reloj. 2.