Full Product Manual

ManualsBrandsNiagara ManualsBath2-piece 0.8 GPF Elongated Toilet in White

For Models:

STEALTH

N7717 - Elongated Single Flush Bowl

N7799 - Elongated Single Flush Bowl with Rear Outlet

N7716 - Round Single Flush Bowl

N7717EB - Elongated Dual Flush Bowl

N7716RB - Round Dual Flush Bowl

N7714 - Single Flush Tank

N7715T - Dual Flush Tank

ONE PIECE

N7711 - One-Piece Toilet

PRODUCT MANUAL

Installation Instructions, Troubleshooting Guide, and Warranty

www.NiagaraCorp.com

Summary of content (5 pages)

PAGE 1
PRODUCT MANUAL Installation Instructions, Troubleshooting Guide, and Warranty For Models: STEALTH N7717 - Elongated Single Flush Bowl N7799 - Elongated Single Flush Bowl with Rear Outlet N7716 - Round Single Flush Bowl N7717EB - Elongated Dual Flush Bowl N7716RB - Round Dual Flush Bowl N7714 - Single Flush Tank N7715T - Dual Flush Tank ONE PIECE N7711 - One-Piece Toilet www.NiagaraCorp.
PAGE 2
INSTALLATION INSTRUCTIONS To insure proper installation carefully read these instructions and be sure you have the proper tools to complete the job. Vitreous china plumbing products are heavy and fragile. To avoid injury or damage, ask for assistance and handle with extreme care. During installation, make sure the plumbing system is vented adequately and that the soil pipe is clean. Be very cautious when working with vitreous china plumbing products.
PAGE 3
6. Install the plastic washer (be sure that the side marked “top” is facing up), round metal washer, and full hex nut. DO NOT OVERTIGHTEN. Cut off any excess bolt length and snap the bolt cap in place. Run a bead of caulk around the base of the toilet for a finished look and to meet plumbing codes. 7. (Skip this step for the one-piece toilet) Install the toilet tank. (The tank has been factory assembled and has the gasket between the bowl and the bottom of the tank and is ready to set in place.
PAGE 4
TROUBLESHOOTING GUIDE PROBLEM: POOR OR SLUGGISH FLUSH Possible Cause: Water supply is blocked. Corrective Action: Shut off water supply, disconnect supply and check water supply valve opening. (Valve is located on wall or floor). Possible Cause: Water level is too low in tank. Corrective Action: Adjust water level in tank to water level mark by turning adjustment screw on FluidmasterTM. Possible Cause: Water supply valve is partially closed. Corrective Action: Open supply valve.
PAGE 5
NIAGARA CONSERVATION WARRANTY INFORMATION Manufacturer’s Limited Lifetime Warranty For Vitreous China Products PLEASE READ CAREFULLY AND RETAIN FOR YOUR RECORDS.