Full Product Manual

1. Place the seat on the toilet, aligning the holes of the seat with the holes in the back of the toilet bowl.
2. Insert the screw through the holes to secure it with the nut from the bottom of the toilet, with the nut’s
tapered end on top.
3. Secure nut from the bottom of the toilet, use a regular screwdriver to tight the fit. (See picture)
CAUTION: DO NOT OVERTIGHTEN THE SCREW AS IT MAY CAUSE DAMAGE ON SEAT.
4. Push the decorative cap down.
TOILET SEAT INSTALLATION INSTRUCTIONS (Seat included in Stealth All-In-One and UHET Kit models)
(Skip this step for the one-piece toilet)
Install the toilet tank. (The tank has been factory assembled and has the gasket
between the bowl and the bottom of the tank and is ready to set in place.) Place the
tank on the toilet bowl. Secure the tank in place with the two (2) metal washers and
(2) nuts provided. DO NOT OVERTIGHTEN.
7.
Connect the water supply to the toilet fill valve and hand tighten. Carefully connect
the water supply to the shut-off valve.
8.
Open the shut-off valve slowly and check for leaks. Fill to the water line. Adjust the
level, if necessary by turning the black screw on top of the float. Turn the screw to
the right to lower the water level or to the left to raise the level.
9.
INSTALLATION AND ADJUSTMENT OF FLUSH BUTTON MECHANISM
The flush button has been factory assembled in the tank lid. Secure the flush button mechanism into the tank lid
by hand tightening the lock nut. The bottom of the push rods leading from the flush buttons should lightly touch,
or slightly backed off from, the top of the flush valve.
To increase the rod length, turn the rod locknut clockwise to loosen, then rotate the push rod clockwise to
increase exposed length. When desired length is achieved turn the rod locknut counter-clockwise, while holding
the push rod, till it is tightened.
To shorten the rod length, turn the rod locknut clockwise to loosen, then rotate the push rod counter-clockwise
decrease exposed length. When desired length is achieved turn the rod locknut counter-clockwise, while holding
the push rod, till it is tightened.
NOTE: When activating the half flush mode, both buttons on the flush mechanism will depress. When activating the full flush mode (chrome button), only the chrome button will
depress. The flush valve mechanism is setup to prevent the full flush from being activated when the green button is pushed.
It is important that the flush rods have equal clearance to assure proper function of the half flush.
6.
Install the plastic washer (be sure that the side marked “top” is facing up), round
metal washer, and full hex nut. DO NOT OVERTIGHTEN. Cut off any excess bolt
length and snap the bolt cap in place. Run a bead of caulk around the base of the
toilet for a finished look and to meet plumbing codes.