Full Product Manual

TROUBLESHOOTING GUIDE
WARNING
Do not place toilet bowl cleaner tablets in toilet tank. The use of these tablets in this manner may cause
leakage and void warranty.
Possible Cause:
Corrective Action:
Possible Cause:
Corrective Action:
Possible Cause:
Corrective Action:
Possible Cause:
Corrective Action:
Possible Cause:
Corrective Action:
Possible Cause:
Corrective Action:
Possible Cause:
Corrective Action:
Possible Cause:
Corrective Action:
Water supply is blocked.
Shut off water supply, disconnect supply and check water supply valve opening. (Valve is
located on wall or floor).
Water level is too low in tank.
Adjust water level in tank to water level mark by turning adjustment screw on Fluidmaster
TM
.
Water supply valve is partially closed.
Open supply valve.
Partially clogged trapway or drain.
Clear passage with an auger. If you are unable to clear blockage, please contact a plumber.
Outlet is partially blocked by wax gasket.
Lift toilet (if your toilet is a back outlet, pull from wall) and replace wax ring gasket.
Water level in tank is set too high.
Refer to installation instructions (Step 8) to adjust the water lever.
Debris lodged in the valve.
Shut off water supply valve; remove front cap from the Fluidmaster
TM
valve by turning
counterclockwise; turn water supply on very slowly and flush out the line.
Fill valve seal may need to be replaced.
Shut off water supply; remove the front cap from the Fluidmaster
TM
valve and replace the
rubber seal disk.
PROBLEM: POOR OR SLUGGISH FLUSH
PROBLEM: FILL VALVE DOES NOT SHUT OFF