Operation Manual

SNMP
198 ViewCast
3.
Verify the Port field is set to 161.
4.
Set SNMP version to v1.
5.
Specify community such as setpassword with community right of READ CREATE.
6.
Specify Set Value to start or stop.
7.
Send SNMP SET request message to the targeted ViewCast SNMP agent.
Start/stop all encoders in the system through SNMP
Use the same steps to load and expand VIEWCAST-AVENCODER-MIB until
.iso.org.dod.internet.private.enterprises.viewcast.avencoder.avencoderMIB.systemCommand.sysComm
and.
To start/stop all encoders in the system through SNMP:
1.
Set object ID to
.iso.org.dod.internet.private.enterprises.viewcast.avencoder.avencoderMIB.systemCom
mand.sysCommand.
2.
Specify correct IP address of the targeted ViewCast SNMP agent: xx.xx.xx.xx
3.
Verify the Port field is set to 161.
4.
Set SNMP version to v1.
5.
Specify community such as setpassword with community right of READ CREATE.
6.
Select Set Value to start_all_encoders or stop_all_encoders.
7.
Send SNMP SET request message to the targeted ViewCast SNMP agent.
Start SNMP trap listener
To start SNMP trap listener:
1.
Locate the VIEWCAST-AVENCODER-TRAP-MIB.txt under C:\Program Files
(x86)\ViewCast\ViewCast SNMP Agent\.
2.
Load the VIEWCAST-AVENCODER-TRAP-MIB.txt into the SNMP manager.
3.
Verify the Port field is set to 162.
4.
Specify community such as notifypassword with at least community right of NOTIFY.
5.
Select Authenticate v1/v2c traps to match community name.
6.
Start the Trap Listener.