Operation Manual

116
Multicast Streaming
If an encoder is connected to IP Output ports configured for multicast streaming (i.e., with a
destination IP address in the range of 224.0.0.0 to 239.255.255.255), the B264 will generate a
web page for that output in the relevant Ethernet port. Note that the video will only actually play
if the network between the client and the encoder supports multicast. This will typically be the
case if the encoder and the client are in the same subnetwork, but may not work across routers
unless they have multicast support enabled, and will definitely not work across the Internet.
The relevant pages are shown below. Both UDP and RTP are supported.