Operation Manual

Encoder 1, Encoder 2 Tabs

The Encoder 1/Encoder 2 Tabs are used to configure/monitor the individual encoder channels.

The parameters in these two tabs are exactly the same.

The B264 can be configured with one or two encoder channels (at the time the unit is ordered,

factory installed). It is possible to upgrade a single channel B264 unit to dual channel by

returning it to Niagara Video.

If an encoder channel is not installed, both its configuration and statistics windows will be empty,

as shown below.

Encoder Configuration Tab

The Encoder Configuration Tab is further divided into the following 3 tabs:

 Basic Tab: contains the more important configuration parameters, which all users are

likely to change.

 Advanced Tab: contains the advanced configuration parameters, which do not

necessarily need to be changed.

 Connections Tab: allows the creation of connections between this encoder and the ASI

and IP output ports.

Configuration Tabs