Operation Manual

 PMT PID, PCR PID, Video PID, Audio PID, SCTE 35 PID: These parameters control

the Packet Identifier (PID) values for the PMT, PCR, Video and Audio. The values can

be entered in hexadecimal (prefixed by 0x) or in decimal. Valid values are from 0x20

(32) to 0x1FFE (8190). PMT PID, Video PID and Audio PID must be distinct values.

PCR PID can either be the same as the video PID or distinct from the other values as well.

The user interface will not accept an invalid entry at any time – it will immediately revert

to the previous value. If additional audio channels are enabled, there will be additional

entries for their corresponding PIDs. The SCTE 35 PID entry is shown only if SCTE 104

Ad Insertion Triggers are enabled.

 Program Number: Enter the desired program number for this encoder channel. Valid

program numbers go from 1 to 65535 and are always entered in decimal.

 Transport Stream ID: Enter the desired Transport Stream ID for this encoder channel.

Values in this field can be entered both in hexadecimal (prefixed by 0x) or in decimal.

 Generate SDT: This box is always shown but is not selectable for the HTTP Live

Streaming and RTMP protocols. If this box is checked, an SDT will be generated for this

encoder channel. Additional SDT parameters become available once this box is checked,

as depicted below.

 Service Name: Enter the desired SDT service name for this encoder channel. The

default name is Slot X Encoder Y, where X is the openGear® slot number where the

B264 is installed, and Y is 1 or 2 (for Encoder 1 or Encoder 2).

 Provider Name: Enter the desired SDT service provider name. The default is MVN.

 Advanced SDT Config: By default, the other SDT values are automatically set by the

system. If you need to configure them, check this box, and a new set of parameters

appears, as shown below.