Operation Manual

 Running Status: Indicates the status of the service. The options are undefined, not

running, starting, pausing, running, and service off-air. The value used for this

parameter when Advanced SDT Config is not enabled is running.

 Service Type: Indicates the type of service. The value used for this parameter when

Advanced SDT Config is not enabled is advanced codec SD digital television service if

the encoder is in SD mode, or advanced codec HD digital television service if the encoder

is in HD mode. The drop-down list offers a few of the most common choices. If you

need to code something other than these choices, select custom setting in the drop-down

list and a new parameter will become available, as show below.

 Custom Service Type: Enter the service type. This field accepts both hexadecimal

(prefixed by 0x) and decimal values. The valid range is from 0 (0x00) to 255 (0xFF).

 Original Network ID: This field contains the Network ID code from which this program

originated. This field accepts both hexadecimal (prefixed by 0x) and decimal values.

Valid values are from 0 (0x0000) to 65535 (0xFFFF). The default value for this field is

0xFF01, which is in the range of values allocated for video over IP. The complete set of

registered Network IDs can be downloaded from this URL:

http://www.dvbservices.com/identifiers/export/original_network_id

 EIT Schedule Flag: Check this box to set the flag. This flag indicates that EIT schedule

information is present for this service. Since the B264 does not generate EITs, the

correct setting of this flag is not set. Only set it if you intend to mux an EIT downstream

of the B264.