Operation Manual

64
 RTMP Protocol: Select the protocol variant, as discussed above.
 Primary Server: Enter the host name or IP address of the primary (or single) RTMP
server to be contacted. If you want to use host names instead of IP addresses, make sure
to configure at least one DNS server. DNS servers may be configured in the Network
Configuration DNS Tab. In the B264, DNS servers can also be configured in the Control
Port Configuration Tab or obtained by DHCP.
 Primary Network Interface: Select the network interface to be used when contacting
the primary server. The settings are:
o Any: use the “best” network interface to connect to the server. In the B264, this
setting allows the encoder to use the control Ethernet port to connect to the RTMP
server, if appropriate.
o Ethernet 1: preferably use Ethernet 1 to connect to the server. If the server is not
in the same subnet as Ethernet 1, and no default gateway is set for Ethernet 1, this
setting will be ignored.
o Ethernet 2: preferably use Ethernet 2 to connect to the server. If the server is not
in the same subnet as Ethernet 2, and no default gateway is set for Ethernet 2, this
setting will be ignored.
 Primary App: Enter the application name in the primary server, as discussed above.
Consult your CDN or server documentation to find out what should be entered in this
field.
 Primary Server URL: This informational field is automatically updated as you
configure the RTMP parameters. It displays the full RTMP URL for the primary server.
 Primary Stream: Enter the stream name for the primary server. Consult your server
documentation or CDN to find out what should be entered here. Some servers allow