Operation Manual

67
 Audio Mute L/R in Analog Audio Parameters
 Audio Type and Dolby PMT Type in PMT Information
Encoder Statistics Tab
The Encoder Statistics Tab is divided into four lower tabs, as indicated below:
The Basic, Advanced and Connections tabs are direct equivalents of their configuration
counterparts. They present the current value of each of the configuration parameters. When the
Apply/Cancel buttons are grayed out, the contents of these tabs exactly match their
configuration counterparts. When the Apply/Cancel buttons are active, configuration
parameters may have been changed. The current (running) encoder configuration can still be
inspected in the statistics tabs, prior to clicking on the Apply button.
The Status Tab provides a summary of the current status of the encoder. The variables
displayed in this tab vary according to the encoder configuration, but the following four basic
parameters are always displayed:
 Encoder 1/2 Status: This gives the overall encoder status. Its values are:
o OK: The encoder is running normally.
o Stopped: The encoder has been manually stopped (see Encoder State in Basic
Tab – General Configuration).
o Error: The encoder should be running but it is not. This status will be briefly
shown when the encoder is starting. The possible causes for this are:
 The encoder has no input (check Encoder 1/2 Video Status)
 There is a mismatch between the video input signal and the encoder
configuration. For example, the input is 1080i and the encoder is
configured for 720p.
 Encoder 1/2 Video Status: This indicates whether or not the selected video input front-
end is locked. This status is also reflected in the rear I/O panel LED next to the video
input. The possible values are: