Operation Manual

70
If the input is SDI and the Audio Source parameter in Basic Tab – Audio Configuration is set to
SDI Embedded Audio, two more indicators are shown:
 Encoder 1/2 Embedded Audio: This indicator flags whether or not embedded audio is
actually present on the selected Group/Channel combination (see Basic Tab – Audio
Configuration). The following values are presented:
o Present: Embedded audio is present in the selected Group/Combination.
o Not Present: The SDI input has no lock, it is not possible to determine
whether embedded audio is present or not.
o Not Present: Embedded audio is not present in the selected Group/Channel
combination. Check the source settings, or select a different Group/Channel
combination.
 Encoder 1/2 Audio Status: This indicator flags any errors in the embedded audio and
will have the following values:
o OK: No errors detected.
o Not Present: Embedded audio is not present – errors cannot be detected. This
status will be issued when there is no SDI lock, or when there is no embedded
audio.
o Error: Embedded audio errors are being detected. If this indicator is red,
audio is corrupted or glitching. The possible causes for this are:
 Corrupted embedded audio in the input – checksum errors
 Audio sampling rate mismatch
 The channel is configured for Dolby Passthrough, and the data present in
the selected Group/Channel is not Dolby AC-3