Operation Manual

-16-
Basic Operation: Using the Niagara Pro Front Panel
Startup
NOTE: If this is the first time Niagara Pro has been started, please read the previous section entitled
First Start Setup before continuing.
To start your Niagara Pro encoder, press the <POWER> button on the front panel.
While powering up, the Niagara Pro LCD readout will display the following series of messages:
When Niagara Pro is ready for operation, the Niagara Pro LCD display will alternate between status
readouts similar to the following:
Shutdown
To shutdown Niagara Pro, briefly press the Power button on the front panel.
The Niagara Pro LCD readout will display the following messages:
After a few seconds, the Niagara Pro will power off.
Caution: Allow the Niagara Pro to power down normally. If you force the system to shutdown
improperly, data can be corrupted. If so, the next time the system is started it can take several
minutes to complete startup.