Installation Instructions

9 – English
1 2
continues

Command
an UP
movement 
“0”
Command
an DOWN
movement 
Hold down the button and... ... wait for the awning to be stopped when it
collides with the box (= UP limit switch = po-
sition “0”).
release the button. Hold down the button and wait...
 2
3 4
 5
“1”
(x 1)
PRG
2
= 5 sec
2
... release the button as soon as the awning
reaches position “1” ( DOWN limit switch).
Press and release
the button (1 time);
count 2 movements. Hold down the but-
ton and
release it after 5 sec-
onds;
count 2 movements.
5 6
end
Finely adjust-
ing the posi-
tion of limit
switch “1” 
“1
”
= 5 sec
3
Press the buttons until you reach the desired position. Al-
ternatively, for more accurate adjustment, run procedure
B.1.
Hold down the button and release it after 5 seconds; count 3 movements.
A.4 - Programming an INTERMEDIATE POSITION (position “H”)
NOTES AND WARNINGS
• This procedure memorises an intermediate position (position “H”) between the Up (“0”) and Down (“1”) limit switch positions. When the automation is being used,
after giving the intermediate position command, the system will automatically stop the awning at the programmed “H” position.
• You can memorise up to 30 “H” positions wherever you wish, provided that these are between the two limit switch positions. These positions can only be pro-
grammed after the limit switch positions. Repeat this procedure for each position you wish to memorise.
• The first “H” position must be programmed using the buttons s+t, on the transmitter used to run the procedure itself. However, each subsequent position
“H” must be programmed using a button on another non-memorised transmitter.
• To change an existing “H” position, move the awning to the desired height and run this procedure; in step 06, however, press the button associated with the exist-
ing “H” position you are changing.
1 2 3
 4
“H”
(x 1)
PRG
2
= 5 sec
2
Move the awning to the
desired “H” position.
Press and release
the button (1 time);
count 2 movements. Hold down both buttons... release them after 5 sec-
onds;
count 2 movements.
4 5 6
...
Precisely ad-
justing the
“H” posi-
tion 
“H
”
= 5 sec
3
Select one of the following potions
and execute it:
• option A – to memorise the
FIRST “H” position.
• option B – to memorise a SUP-
PLEMENTARY “H” position.
Press the buttons until you reach the desired position.
Alternatively, for more accurate adjustment, run pro-
cedure B.1.
Hold down the but-
ton and
release it after 5 sec-
onds;
count 3 movements.
option – A
6
end
option – B
6
end
= 5 sec
4
= 5 sec
...
...
4
Hold down both but-
tons...
release them after
5 seconds;
count 4 movements. On ANOTHER transmitter,
which has NOT been memo-
rised: hold down any button
you wish;
release it after
5 seconds;
count 4 movements.
A