Installation Instructions

15 – English
A.12 - Precise adjustment of the UP (“0”) and DOWN (“1”) limit switch positions (procedure
to be run with the keys on the head of the motor)
NOTES AND WARNINGS
• This adjustment can be done at any time, on condition that the limit switch positions have already been programmed.
• The following procedure describes the setting of the Upper limit switch “0”. To adjust the Lower limit switch “1”: (in step 1) command a DOWN movement (rather
than UP); (in step 2) adjust the height of limit switch “1” (instead of the height of limit switch “0”); (in step 3) as in the figure below.
1 2
 3
Command
an UP
movement 
(x 1)
“0”
Adjust the po-
sition of limit
switch “0”. 
“0”
Press and release the key. Wait for the move-
ment to finish at posi-
tion “0”.
Press the buttons until you reach the desired position.
Note – Each step of the motor corresponds to a rotation
of around 2°.
3
end
= 5 sec
3
Hold down either of the two buttons; release it after 5 seconds; count 3 movements.
A
A.13 - “Slider” setting (transmitters with “slider” surface only)
NOTES AND WARNINGS
• If you control the automation with a Nice transmitter equipped with a “slider” surface (P1V, etc.), you can set the speed of movement or the stop position of the au-
tomation, depending on the function associated with the “slider” itself.
• The following procedure describes how to set the function of the “slider” out of the two possible options: speed (factory setting) or position.
1 2 3
 4
PRG
(x 1)
2
PRG
(x 1)
2
PRG
(x 1)
3
Press and re-
lease the button (1
time);
count 2 movements. Press and re-
lease the button (1
time);
count 2 movements. Press and re-
lease the button (1
time);
count 3 movements.
4 5
...
4
Select one of the following options and
execute it:
• option A – sets the “slider” as the au-
tomation’s position control
• option B – sets the “slider” as the au-
tomation’s speed control
Press and release
the two keys to-
gether;
count 4 movements.
option – A
5
fine
option – B
5
fine
3
5
Press and release the key; count 3 movements. Press and release the key; count 5 movements.
A