Installation Instructions

17 – English
B.2 - TOTAL or PARTIAL deletion of memory
NOTES AND WARNINGS
• In order to carry out the following deletion procedures, the transmitter must be memorised in mode I.
B.2.1 - Procedure run with a memorised transmitter
1 2 3
 4
PRG
(x 1)
2
PRG
(x 1)
2
PRG
(x 1)
3
Press and release
the button (1 time);
count 2 movements. Press and release
the button (1 time);
count 2 movements. Press and release
the button (1 time);
count 3 movements.
4 5
...
PRG
(x 1)
4
Select one of the following potions and execute it:
• option A – delete the motor’s ENTIRE memory
• option B – delete ALL memorised transmitters
• option C – delete ONE memorised transmitter
• option D – delete ALL positions (“0”, “1”, “H”, etc.). Caution! – This deletion should only be performed if you wish re-
program the distances using a procedure different from the one used previously (e.g. you have used manual distance pro-
gramming (A.2) and would now like to use the semi-automatic procedure (A.3).
Press and release
the button (1 time);
count 4 movements.
option – A
5
end
option – B
5
end
PRG
(x 1)
5
= 5 sec
5
Press and release the
button (1 time);
count 5 movements. Hold down the button and release it after 5 seconds; count 5 movements.
option – C
5 6
end
= 5 sec
3
= 5 sec
5
Hold down the but-
ton and
release it after 5
seconds;
count 3 movements. On the transmitter to be deleted: hold down any
key either the key memorised in mode 2 or the cli-
matic conditions sensor;
count 5 movements.
option – D
5
end
= 5 sec
5
Hold down both buttons... release them after 5
seconds;
count 5 movements.
A