Installation Instructions

4 – ENGLISH
MEMORISING THE TRANSMITTER
3
3 MEMORISING THE TRANSMITTER
3.1 TRANSMITTER VERIFICATION
Before memorising the transmitter in the automation’s receiver, en-
sure that it is working correctly by pressing any button while observing
whether LED (A) lights up.
If LED (A) fails to light up, check the condition of the battery and re
-
place it if necessary (refer to the “REPLACING THE BATTERY” par-
agraph on page 5).
A
3
3.2 MEMORISING THE TRANSMITTER
To memorise the transmitter in a receiver, the following procedures can
be adopted:
– memorisation in “Mode 1”
– memorisation in “Mode 2”
– memorisation in “Extended Mode 2”
– memorisation through the “Enabling Code” received from a previ
-
ously memorised transmitter.
l
These procedures are described in the instruction
manual of the receiver or control unit with which
the transmitter must be operated. The above-men-
tioned manuals are also available on the website:
www.niceforyou.com.
3.2.1 MEMORISATION IN “MODE 1”
This mode allows for memorising in the receiver, once only, all the
transmitter command buttons, associating them automatically with
each command managed from the control unit (default commands).
l
Refer to the control unit instructions to identify the
type of command that will be paired with each trans-
mitter button.
3.2.2 MEMORISATION IN “MODE 2”
Allows for memorising in the receiver a single transmitter button, asso-
ciating it with the commands managed from the control unit (maximum
4, chosen by the user).
l
The same procedure must be repeated for each button
to be memorised.
3.2.3 MEMORISATION IN “EXTENDED MODE 2”
This procedure is the same as the memorisation in “Mode 2”, with
the added possibility of choosing the desired command (to be paired
with the button being memorised) in an extended list of commands
managed from the control unit (up to 15 different commands).
l
Refer to the control unit instructions to identify the ex-
tended list of commands.
3.2.4 MEMORISATION THROUGH THE “ENABLING CODE”
(BETWEEN AN OLD TRANSMITTER ALREADY
MEMORISED AND A NEW TRANSMITTER)
The MYGOBD (MYGOBD/A) transmitter has a secret code, the so-
called “ENABLING CODE”. By transferring this code from a memo
-
rised transmitter to a new transmitter, the latter is recognised (and
memorised) automatically by the receiver.
To perform the memorisation procedure:
1. Draw the two transmitters, NEW and OLD, near to one another,
as shown in “Figure 4”.
Old New
4
2. Press and release any command button on the NEW trans-
mitter. LED (A) of the OLD transmitter will switch on and start
ashing.
Old New
A
5
3. On the OLD transmitter press and release any command but-
ton. Once the code has been transferred, for an instant both the
transmitters (NEW and OLD) will vibrate and their green LEDs
(A) will light up (end of the procedure).
Old New
A
A
6
l
After passing the enabling code on the NEW trans-
mitter, for the procedure to succeed the transmitter
– within the rst 20 transmissions – must be used at
least once near the automation.