User's Manual

FCCWARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the condition
that this device does not cause harmful interference (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
thatmaycauseundesiredoperation.
Chang
esormodificationsnotexpresslyapprovedbythepartyresponsibleforcompliance
couldvoidtheuser'sauthoritytooperatetheequipment.
NOTE: This equipmenthasbeen tested and foundto comply with the limitsfor aClass B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to pr
ovide reasonable
protection against harmful interference in a residential installation. This equipment generates,
usesandcanradiateradiofrequencyenergyand,ifnotinstalledandusedinaccordancewiththe
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a parti
cular installation. If this equipment does
causeharmfulinterferencetoradioortelevisionreception,whichcanbedeterminedbyturning
the equipment off and on, the user is encouraged to try to correct the interference by one or
moreofthefollowingmeasures:
‐‐Reorientorrelocatethereceivingan
tenna.
‐‐Increasetheseparationbetweentheequipmentandreceiver.
‐‐Connecttheequipmentintoanoutletonacircuitdifferent
fromthattowhichthereceiverisconnected.
‐‐Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
ThedevicehasbeenevaluatedtomeetgeneralRFexposurerequirement.Thede
vicecanbeused
inportableexposureconditionwithout
restriction.
FCCID:2AD66‐4463H1

This device is intended only for OEM integrators under the following conditions:
1)Theantennamustbeinstalledsuchthat20cmismaintainedbetweentheantennaandusers,
and
2)Thisdeviceanditsantenna(s)mustnotbeco‐locatedwithanyothertransmittersexceptin
accordancewithFCCmulti‐transmitterproductprocedures.Referringtothemulti‐transmitter
policy,multiple‐transmitter(s)andmodule(s)ca
nbeoperatedsimultaneouslywithoutC2P.
3)ForallproductsmarketinUS,OEMhastolimittheoperationchannelsinCH1toCH11for2.4G
bandbysuppliedfirmwareprogrammingtool.OEMshallnotsupplyanytoolorinfotothe
end‐userregardingtoRegulatoryDomainchange.

USER
SMANUALOFTHEENDPRODUCT:
Intheusersmanualof theend product,the enduser hastobe informedtokeepatleast20cm
separationwiththeantennawhilethisendproductisinstalledandoperated.Theenduserhasto
beinformedthat theFCC radio‐frequencyexposure guidelines fo
ran uncontrolledenvironment
can be satisfied. The end user has to also be informed that any changes or modifications not
expressly approved by the manufacturer could void the user's authority to operate this
equipment.Ifthesizeoftheend productissmallerthan8x10cm,thenadditionalFCCpart15
.19
statementis required to be available in the users manual: This device complies with Part 15 of