Users Manual

www.nicerf.com
LoRa1280/1F27
NiceRF Wireless Technology Co., Ltd. Rev 1.1
[e-mail]
-11-
This device is intended only for OEM integrators under the following conditions:
1. The antenna must be installed such that 20 cm is maintained between the antenna and
users.
2. The transmitter module may not be co-located with any other transmitter or antenna. As
long as the two conditions above are met, additional transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required for the installed module.
Important Note:
In the event that these conditions cannot be met (for example certain laptop configurations or
co-location with another transmitter), then the Federal Communications Commission of the
U.S. Government (FCC) and the Canadian Government authorizations are no longer
considered valid and the FCC ID and IC ID cannot be used on the final product. In these
circumstances, the OEM integrator shall be responsible for re-eval uating the end-product
(including the transmitter) and obtaining a separate FCC and IC authorization in the U.S. and
Canada.
OEM Integrators - End Product Labeling Considerations:
This transmitter module is authorized only for use in device where the antenna may be
installed such that 20 cm may be maintained between the antenna and users. The final end
product must be labeled in a visible area with the following: “Contains , FCC ID:
2AD66-LORA128XF27. The grantee's FCC ID can be used only when all FCC compliance
requirements are met.
OEM Integrators - End Product Manual Provided to the End User:
The OEM integrator shall not provide information to the end user regarding how to install or
remove this RF module in end product user manual. The end user manual must include all
required regulatory information and warnings as outlined in this document.