User's Manual

www.nicerf.com
4) Rx Test Mode: RF module is always in Rx mode;
5) Standby Mode: RF module is always in standby state.
 Button Operation:
1) [SET] Button
Press the [SET] button to enter into setting mode; Or press the [SET] button to be out of the setting
mode upon the last parameter is done.
2) [UP/Down] Button
In setting mode, press the [UP/Down] button to increase/decrease the value of flash icon.
Note: The DEMO board has FLASH memory inside, all the setting parameters will be saved automatically and
keep unchanged even power-off.
Appendix 2: SMD Reflow Chart
We recommend you should obey the IPC related standards in setting the reflow profile:
TEL:[phone] FAX:[phone] Email：[e-mail] 第 7 页 共 8 页
2
.4G RF module with nRF2401+