Instructions / Assembly

Find your niche

VERSATILE AND MODERN

MIA RECLINING CHAIR

N2020LNTBK & N2050LNTBK

BEFORE YOU ASSEMBLE:

• Place all parts on a clean, smooth surface to avoid scratching the parts

• Check to be sure you have all parts and hardware

• Remove all wrapping materials, including any staples & packing straps

• Keep all hardware, small parts and packaging out of reach of children

ASSEMBLY INSTRUCTIONS

IN THE BOX:

A: Wood Frame (2)

B: Stringer (2)

D: Seat Frame (1)

I: Seat

Cushion

(1)

C: Back Frame (1)

E: Medium Bolt (4)

F: Small Bolt (2)

G: Long Bolt with Insert (4)

H. Threaded

Flange (2)

J. Allen Wrench

(1)

K. Headrest

PAGE 1
Find your niche VERSATILE AND MODERN ASSEMBLY INSTRUCTIONS BEFORE YOU ASSEMBLE: MIA RECLINING CHAIR N2020LNTBK & N2050LNTBK • Place all parts on a clean, smooth surface to avoid scratching the parts • Check to be sure you have all parts and hardware • Remove all wrapping materials, including any staples & packing straps • Keep all hardware, small parts and packaging out of reach of children IN THE BOX: A: Wood Frame (2) B: Stringer (2) C: Back Frame (1) D: Seat Frame (1) E: Medium Bolt (4) F: Smal
PAGE 2
Find your niche VERSATILE AND MODERN ASSEMBLY INSTRUCTIONS MIA RECLINING CHAIR N2020LNTBK & N2050LNTBK STEP 1 Attach Stringers (B) to Wood Frames (A). Remove Inserts from Large Bolts (G) and place Inserts into pre-drilled holes on Stringers (B) (See Figure 1.) Insert Large bolts (G) from outside of Wood Frames (A) and connect to Inserts using Allen Wrench (H). Please Note: Do not completely tighten bolts yet.
PAGE 3
Find your niche VERSATILE AND MODERN ASSEMBLY INSTRUCTIONS IN THE BOX MIA RECLINING CHAIR N2020LNTBK & N2050LNTBK N2050LNTBK OTTOMAN M: Stringers (2) L: Cushion (1) O: Long Bolt with Inserts (4) N: Wood Frame (2) P: Medium Bolts (4) STEP 2 STEP 1 Attach Stringers (M) to Wood Frames (N). Remove Inserts from Large Bolts (O) and place Inserts into pre-drilled holes on Stringers (M) (See Figure 4.) Insert Large bolts (O) from outside of Wood Frames (N) and connect to Inserts using Allen Wrench (J).