Technical Specifications

13
CUTTING ULTIMATE CLIPS
JEL777/787 Panel Clips are 26” long. Where
full length clips can be used, they are
required. However, there may be conditions
where clips must be cut to accommodate
panels or corner pieces in smaller areas or
segments such as narrow columns, pilasters,
or insets, recessed openings, or small areas
between windows.
Notches on the upward panel engagement
flanges indicate where clips can be cut evenly
into thirds. These 1/3 segments can be further
reduced evenly into two or four pieces each
with weep holes serving as dividing points.
The smallest segment must include at least
one downward panel engagement flange.
Always use the widest clip segment possible.
Cut with a non-ferrous saw blade on a band or
chop saw.
Fig. 24
Fig. 25