SDS

A-001-10 Nichiha AWP (EX Series) Safety Data Sheet
2/4
・Seek medical attention as needed if exposed to dust or feel sick as a result.
Disposal
・Follow applicable local, state, and federal construction waste management requirements. Prevent potential
dust exposure for others.
[3. COMPONENT/INFORMATION ON INGREDIENTS]
Classification of single product or mixture: Mixture
Ingredients: Cement, silicate material, organic fiber, additives
・The product contains 2 to 12% of crystalline silica. Also, the cement may contain up to 2% of calcium
oxide.
NAME CAS Number %content
Crystalline silica (Quartz) 14808-60-7 2 ~ 12
Calcium Oxide 1305-78-8 2
Cellulose 9004-34-6 10 ~ 20
・If the product is coated, the coating film may contain pigments, but the content of pigments in the
product is less than 0.1%.
・The product does not contain asbestos.
・The product does not contain formaldehydes. Chlorpyrifos has not been added.
[4. FIRST AID]
Eye contact: Immediately wash the eye for at least 15 minutes using clean water and then seek
attention of a doctor.
Skin contact: Immediately wash the skin thoroughly with water and seek medical attention as
needed.
Inhalation: Immediately move to a place with fresh air, gargle with water, and seek medical
attention as needed.
Ingestion: Wash the inside of the mouth thoroughly with water and seek medical attention.
If the victim is groggy or unconscious, do not induce vomiting, but seek medical
attention without delay.
When exposed or potentially exposed to dust: Seek attention/treatment of a doctor.
[5. MEASURES TAKEN IN CASE OF FIRE]
Extinguishing method: Cut off the combustion path to the source of fire and extinguish the fire using water and
fire-extinguishing medium. Fight the fire from the upwind side and wear respiratory
protection gears if necessary.
Fire-extinguishing media: Water, powder, carbonic acid gas, foam
[6. MEASURES TAKEN IN CASE OF LEAK]
The product is normally in a solid sheet-shaped state, so no special measures are needed.
[7. HANDLING AND STORAGE PRECAUTIONS]
Handling: ・Wear protective gloves (work gloves, etc.) when handling the product.
・Provide local exhaust measures when cutting the material and use cutting equipment with anti-
dust function. Also wear proper protective equipment (anti-dust mask, protective goggles, etc.)
so as not to inhale powder dust or let it enter your eyes.
・Do not wet the product.
・Clean dust with HEPA filter equipped vacuum. Do not dry sweep or use compressed air.
・Rinse your face, hands, mouth, etc., with water after handling the product.