Installation Instructions

17
FREQUENCY SETTING
The first line allows you to set the frequency:
Pressing the rotary switch you can choose the frequency steps between 100 KHz or 10
KHz. Then turning the rotary knob you can reach the desired frequency. Confirmation is
done by pressing the rotary encoder for a few seconds.
After confirmation, the RF module is turned off processing a new PLL frequency locking;
The PLL and ON-AIR LEDs are switched on after the locking time is complete. During the
locking time, the traffic light turns yellow and then turns green once the procedure is
complete.
MENU SETUP
3) MONO INPUT
4) MPX INPUT
1) FREQUENCY SETUP
2) RF POWER SETTING
MHz 98.000
FREQUENCY SETUP
100KHz
10KHz
PUSH
FREQUENCY:MHz 88.000
FREQUENCY SETUP
100KHz
10KHz
PUSH
CONFIRM? YES NO
YES
FREQUENCY SETUP
RF FORWARD: 0 W RF FEFLECTED: 0 W
WAIT
PLL LOCK IN PROGRESS