Installation Instructions

19
INPUT MONO SETTING
The MONO input is the XLR connector. It is shared with the LEFT input of the STEREO
CODER module. By choosing this option you can set some parameters of the MONO
input, including the input impedance, pre-emphasis and amplification gain:
Each access to these parameters gives the possibility of switching from one value to
another through the rotary encoder and confirming the choice by pressing it:
MENU SETUP
1) FREQUENCY SETUP
2) RF POWER SETTING
3) MONO INPUT
4) MPX INPUT
MONO INPUT
a) IMPEDANCE 10 KΩ
b) PRE-EMPHASIS 75μSS
d) EXIT
c) GAIN 0.0 dBS
MONO INPUT - IMPEDANCE
600 Ω
10 KΩ
MONO INPUT - IMPEDANCE
600 Ohm
10 KOhm
CONFIRM? YES NO
YES