Installation Guide

INSTALLATION
INSTRUCTIONS
WARNING: Before wiring to the power supply, turn off the electricity at fuse or circuit breaker
box. Ensure grounding to avoid potential electrical shock and to ensure reliable lamp starting.
PREPARATION OF LIGHT FIXTURE FOR INSTALLATION
1) Remove the Acrylic lens from the fixture and place aside on a flat surface to avoid damage
to the lens. To remove the lens, release the four "Lens-Locks" located 2 on either side of
the light from the closed position to the open position. Gently lift up the lens one side
first followed by the other side.
2) Squeeze wireway cover at both ends on both sides to release from the fixture housing.
Remove the cover and place aside on a flat surface for later use.
3) Carefully turn the fixture housing over and locate the center knockout on the housing. Make
sure the fixture housing is supported on the underside and then by placing a screwdriver
on the edge of the knockout ( opposite retaining tabs ), strike the screwdriver end by the
use of a hammer ( SAFETY GLOVES AND GLASSES SHOULD BE WORN WHEN
REMOVING ANY KNOCKOUTS ). Grasp the knockout with the use of pliers and flex in
a back and forth motion until the tab breaks off.
4) Coordinate mounting position in the room. Supply wires of house wires will extend from the
" JUNCTION BOX " located in the ceiling. If you not have a " JUNCTION BOX " in the ceiling,
consult a qualified professional electrician.
CAUTION
Check both the fixture and house for loose or damaged wiring. If the wiring is loose or
damaged, it must be repaired prior to the fixture installation. DO NOT PROCEED ON
UNTIL THE WIRING HAS BEEN FIXED OR REPLACED WITH NEW WIRES.