Installation Guide

ManualsBrandsNicor Lighting ManualsCeiling LightsCLR-Select 8-in Aged Copper Commercial Canless LED Downlight Kit

What’s In The Box

One (1) CLR Five (5) Wire NutsOne (1) MC Connector

ATTENTION:

• Turn power o before inspection, installation, or removal.

• Suitable for use in dry, damp and wet indoor and outdoor locations. Use only on 120-277 VAC, 60Hz circuits.

NOTE:

• Not all existing mounting frames will be compatible with the CLR. To ensure compatibility, a test installation should be conducted.

• The CLR LED Retrot Kit is designed to be installed in a standard 6” or 8” CFL mounting frame.

CLR Select Commercial Recessed LED Downlight

INSTALLATION INSTRUCTIONS

Model(s):

CLR62SWRVS9WH

CLR82SWRVS9WH

CLR82HWRVS9WH

Tools Needed Frame Compatibility

This LED Recessed Kit requires very few tools for

installation. A screwdriver and a pair of wirecutters will

help to install the downlight to a JBox or housing.

CLR6: 5½” min - 7” max

CLR8: 7¼” min - 9” max

Remove existing

lamp, trim and

socket cap.

Remove J-Box cover plate from existing lamp ballast. Do

not dispose. Disconnect all wires from ballast. Remove

the socket cap metal conduit (MC) cable from the J-Box.

CLR Kit Installation With Existing Frame

Make sure all power is turned o before beginning installation

WARNING:

• Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing.

• To prevent early lamp failure, lamp should only be installed in operating environments between -20°C and + 40°C (104°F and -4°F)

• No user serviceable parts inside. To avoid electric shock do not disassemble product.

• This product is not intended for use in emergency light xtures or exit signs.

• This product is contains a chemical know to the state of California to cause cancer, birth defects and other reproductive harm.

• Risk of re or electrical shock. Install this kit only in luminaires that have the construction features and dimensions shown in

the photographs and/or drawings.

• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.

Summary of content (4 pages)

PAGE 1
CLR Select Commercial Recessed LED Downlight INSTALLATION INSTRUCTIONS Model(s): CLR62SWRVS9WH CLR82SWRVS9WH CLR82HWRVS9WH WARNING: • Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing. • To prevent early lamp failure, lamp should only be installed in operating environments between -20°C and + 40°C (104°F and -4°F) • No user serviceable parts inside. To avoid electric shock do not disassemble product.
PAGE 2
CLR Kit Installation With Existing Frame 3 Make sure all power is turned off before beginning installation Fasten the LED retrofit kit MC cable to the J-Box using the included MC connector. 4 Adjust CCT or Lumen output by setting the switch positions on the back of the fixture to the desired settings.
PAGE 3
CLR Kit Installation Without Existing Frame Make sure all power is turned off before beginning installation 1 Identity fixture location and cut rough-in hole. Cut a 5½” to 2 Fasten the LED 7” diameter hole for CLR6 and a 71/2” to 91/4” diameter hole for CLR8. retrofit kit MC cable to a field installed j-box (not supplied) per local electrical code using a standard MC connector (not supplied).
PAGE 4
5 Install J-Box cover plate. 7 Turn on power and verify proper operation. 6 Lift upward on retention tabs while pushing the retrofit kit through the rough-in, release the retention tabs and push trim flush to the ceiling, ensuring a secure fit. EXPRESS LIMITED WARRANTY Subject to the exclusions contained below, NICOR Inc.