How to Guide

What’s In The Box

One (1) DCR

One (1) Edison Adaptor

WARNING:

•Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing.

•To prevent early lamp failure, lamp should only be installed in operating environments

between -20°C and + 40°C (-4°F and 104°F)

•No user serviceable parts inside. To avoid electric shock do not disassemble product.

•This product is not intended for use in emergency light xtures or exit signs.

ATTENTION:

Turn power o before inspection, installation, or removal.

Suitable for use in wet locations.

Use only on 120VAC, 60Hz circuits.

DCR4 Recessed LED Downlight

INSTALLATION INSTRUCTIONS

Model:

DCR4106120

Tools Needed

The DCR Recessed LED Downlight is designed to t into a

4” housing. No tools are necessary for installation.

Disconnect Edison base

from downlight and

screw into socket inside

recessed housing.

(GU24 base option available).

Carefully route wires into housing and push the

downlight upward, ush to ceiling surface.

Plug the downlight connector into the Edison

(or GU24) base connector.

Make sure all power is turned o before beginning installation

Align friction clips with recessed housing.

Carefully unpack the downlight from its packaging. Inspect product for defects due to shipping.

NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393

www.nicorlighting.com November 9, 2017 9:13 AM

Installing the DCR

If using optional colored trim, align trim onto downlight and secure by bending over tabs.

4.02”

102 mm

4.72”

120 mm

Minimum Lamp

Compartment Dimensions

PAGE 1
DCR4 Recessed LED Downlight INSTALLATION INSTRUCTIONS Model: DCR4106120 WARNING: •Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing. •To prevent early lamp failure, lamp should only be installed in operating environments between -20°C and + 40°C (-4°F and 104°F) •No user serviceable parts inside. To avoid electric shock do not disassemble product. •This product is not intended for use in emergency light fixtures or exit signs.
PAGE 2
EXPRESS LIMITED WARRANTY Subject to the exclusions contained below, NICOR Inc. (NICOR) warrants that all NICOR LED branded Solid State Lighting products made by NICOR to be free from defects in materials and workmanship, under normal consumer usage for a period of 5 years from date of purchase. This limited warranty is a consumer’s exclusive remedy, and applies only to new products purchased and used by consumers in the United States or Canada, which are accompanied by this written warranty.