Installation Guide

NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com August 24, 2018 2:31 PM

What’s In The Box

One (1) DLE

(Round or Square Trim Avaliable)

ROUGHIN-TEMPLATE-#*

( “#” = Fixture Diameter: 3”, 4”, 6”, 8”)

One (1) Driver

ATTENTION:

• Turn power o before inspection, installation, or removal.

• Suitable for use in dry, or damp indoor and outdoor locations. Use only on 120 VAC, 60Hz circuits.

DLE Edge Lit Surface Mount LED Downlight

INSTALLATION INSTRUCTIONS

General Steps

WARNING:

• Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing.

• To prevent early lamp failure, lamp should only be installed in operating environments between -20°C and + 40°C (104°F and -4°F)

• No user serviceable parts inside. To avoid electric shock, do not disassemble product.

• This product is not intended for use in emergency light xtures or exit signs.

• This product contains a chemical known to the state of California to cause cancer, birth defects and other reproductive harm.

• Risk of re or electrical shock. Install this kit only in luminaires that have the construction features and dimensions shown in

the photographs and/or drawings.

• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.

DLE4-RD/SQ: 4.25” diameter

DLE6-RD/SQ: 6.25” diameter

Tools & Materials Needed

This LED Recessed Downlight requires very few tools for

installation. A drill or a screwdriver and a pair of wirecutters, and

appropriate fasteners for mounting surface

Turn o power to appropriate

circuit at the breaker box.

Alternate:

Install Rough in Plate to ceiling joist at desired

location using appropriate fasteners (not

provided). Install drywall to ceiling using

appropriate fasteners (not provided) and cut

out Rough in Plate opening.

*Accessories not included, not requrired for installation.

Optional Accessories

DLE Colored Trim*

(See Ordering Sheet for color options)

Identify location for installation and cut hole in

ceiling per the following table:

PAGE 1
DLE Edge Lit Surface Mount LED Downlight INSTALLATION INSTRUCTIONS WARNING: • Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing. • To prevent early lamp failure, lamp should only be installed in operating environments between -20°C and + 40°C (104°F and -4°F) • No user serviceable parts inside. To avoid electric shock, do not disassemble product. • This product is not intended for use in emergency light fixtures or exit signs.
PAGE 2
3 DRIVER Open driver cover, remove knock-out, feed wires through knock-out and make wiring connections as show in wiring diagram, then close driver cover. Black (line) Black (line) Ground Green (ground) LINE White (neutral) White (neutral) 4 Only for Colored Trim: Place trim over downlight and bend down metal tabs to secure trim to downlight. 5 Connect driver wire to DLE wire, ensuring the connectors are properly aligned and fully screwed down. 6 Place driver box into ceiling.
PAGE 3
LED EXPRESS LIMITED WARRANTY Subject to the exclusions below, each NICOR LED product, including the LED electronics and components of a property installed NICOR LED product, will be free from defect in materials and workmanship for a period of five (5) years from the original date of purchase. The product shall be considered defective only if 10% or more of the product’s LED components fail.