Installation & Assembly

Check both the fixture and power supply for loose or damaged wiring. If the wiring is loose or
damaged, it must be repaired prior to the fixture installation. DO NOT PROCEED
UNTIL THE WIRING HAS BEEN FIXED OR REPLACED WITH NEW WIRES.
NOTE: This fixture is designed to be surfaced mounted on a drywall ceiling. Mounting
hardware requirements will depend on mounting method.
A) For mounting on drywall ceilings:
1) Lift fixture housing to the ceiling, positioning
the center knockout of the housing over
the junction box and parallel to the ceiling.
See Diagram 1.
2) Mark ceiling with a pencil for the drill hole
locations through the narrow portion on the 4
keyhole slots. See Diagram 2, 3.
3) Drill 1/8" pilot hole at each location.
4) If drill encounters ceiling joist, use wood
screws ( provided ) & washers ( not
included ) to secure fixture housing to the
ceiling. See diagram 4.
5) If drill DOES NOT ENCOUNTER CEILING
JOIST, use 4 toggle bolts and washers
( both not included ). Enlarge the pilot drill
hole size large enough to accommodate
the toggle bolts tighten and secure fixture
housing to ceiling. See Diagram 5.
6) Reinforce the mounting of the housing to the
ceiling by adding a board between the
expansion part of the toggle bolt and the
ceiling tile. See Diagram 6.
INSTALLATION INSTRUCTIONS
MOUNTING OF THE LIGHT FIXTURE
SAFETY TIP
Diagram 2
Diagram 3
Diagram 4
Diagram 5
Diagram 6
Diagram 1