Installation Guide

ManualsBrandsNICOR ManualsCommercial LightingACW 220-Watt Equivalent High-Output White Integrated LED Wraparound Ceiling Light Fixture, 4000K

CAUTION:

For your safety and proper operation of this fixture, read instructions

carefully before you start. Note and understand all safety information in

bold print

1) WARNING: RISK OF SHOCK

House electric current can cause painful shock or serious injury unless handled properly.

For your safety, always remember to:

-Turn off the power supply at the fuse or circuit breaker box before you install the fixture.

-Turn off the power supply again when you change lamps or perform other maintenance.

-Ground the fixture to avoid potential electric shocks and to ensure reliable starting.

-Double check all connections to be sure they are all tight and correct.

-Wear rubber-soled shoes and work on a sturdy wooden ladder.

2) This fixture is designed for use in a circuit protected by a fuse or circuit breaker. It is also

designed

to be installed in accordance with local electrical codes. If you are unsure about the

wiring, consult a qualified electrician and check your local electircal code.

3) WARNING: RISK OF CUTS

Some metal parts in the fixture may have sharp edges. To prevent possible cuts and scrapes, we

suggest gloves to be worn when handling all parts from this fixture.

4) Account for small parts and destroy packing material, as these may be hazardous to children.

5) WARNING: RISK OF FIRE

Most dwellings built before 1985 have supply wire rated 60°C. If supply wires are located within 3

inches of the ballast, wire must be suitable for at least 90 C ( 194 F ). Consult a qualified

electrician before installing.

A) LAMP HOUSING 1 UNIT C) WIREWAY COVER 1 UNIT A) PLIERS C) PHILPS SCREWDRIVER

B) LENS 1 UNIT D) WOOD SCREWS 4 UNITS B) HAMMER D) SAFETY CLASSES

E) WIRENUTS 3 UNITS

INSTALLATION INSTRUCTIONS

WRAP AROUND LIGHT FIXTURE

IMPORTANT SAFETY INFORMATION

FOR YOUR PROTECTION, READ CAREFULLY

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS CAUTION: For your safety and proper operation of this fixture, read instructions carefully before you start. Note and understand all safety information in bold print. WRAP AROUND LIGHT FIXTURE IMPORTANT SAFETY INFORMATION FOR YOUR PROTECTION, READ CAREFULLY 1) WARNING: RISK OF SHOCK House electric current can cause painful shock or serious injury unless handled properly.
PAGE 2
INSTALLATION INSTRUCTIONS WARNING: Before wiring to the power supply, turn off the electricity at fuse or circuit breaker box. Ensure grounding to avoid potential electrical shock and to ensure reliable lamp starting. PREPARATION OF LIGHT FIXTURE FOR INSTALLATION 1) Remove the Acrylic lens from the fixture and place aside on a flat surface to avoid damage to the lens. To remove the lens, carefully slide the lens to one end of the fixture. Gently grab the lens and pull it out.
PAGE 3
INSTALLATION INSTRUCTIONS NOTE: This fixture is designed to be surfaced mounted on a drywall ceiling. Mounting hardware requirements will depend on mounting method. MOUNTING OF THE LIGHT FIXTURE A) For mounting on drywall ceilings: 1) Lift fixture housing to the ceiling, positioning the center knockout of the housing over the junction box and parallel to the ceiling. See Diagram 1. Diagram 1 2) Mark ceiling with a pencil for the drill hole locations throuth the narrow portion on the 4 keyhole slots.
PAGE 4
INSTALLATION INSTRUCTIONS WARNING: Before wiring to the power supply, turn off the electricity at fuse or circuit breaker box. Ensure grounding to avoid potential electrical shock and to ensure reliable lamp starting. WIRING OF THE LIGHT FIXTURE 1) Connect the black supply ( line ) wire to the black wire from the light fixture. Secure the connection by inserting into the wirenut, then revolving until secure.Diagram 1.