Installation Guide

CLR Kit Installation Without Existing Frame
Make sure all power is turned o before beginning installation
Make wiring connection to junction box.
a. Connect Black wire to line wire.
b. Connect White wire to neutral wire
c. Connect Green wire to ground wire
d. Route and connect Purple and Grey 0-10V dimming control wires in accordance with dimmer instructions
and electrical code.
Identity xture location and cut rough-in hole. Cut a 5½” to
7” diameter hole for CLR6 and a 7½” to 9¼” diameter hole
for CLR8.
Fasten the LED
retrot kit MC
cable to a eld
installed j-box
(not supplied)
per local
electrical code
using a standard
MC connector
(not supplied).
3
1 2
Install J-Box
cover plate.
Lift upward on retention tabs while pushing the retrot kit
through the rough-in, release the retention tabs and push
trim ush to the ceiling, ensuring a secure t.
4 5
J-Box
LINE
Black (line)
Ground
White (neutral)
Purple (dim +)
Grey (dim -)
Black (line)
Green (ground)
White (neutral)
Purple (dim +)
Grey (dim -)
CLR
Turn on power and verify proper operation.
6
NOTE: If 0-10V dimming is NOT to be connected, it is recommended to cut o the exposed, tinned leads on the purple and
grey wires, and cover the ends with a small piece of electrical tape or wire nut. If bare 0-10V control wires should
accidentally touch a grounded surface, it could cause unintended ickering or dimming of the light xture.
CLR6 CLR8
5½” to 7” diameter
7½” to 9¼” diameter
Turn over for warranty information.