Installation Guide

ManualsBrandsNICOR ManualsLightingSureFit 5 in. White Recessed Square Trim

What’s In The Box

One (1) DLF

Three (3) Push-in Connectors

Two (2) Screws

WARNING:

•Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing.

•To prevent early lamp failure, lamp should only be installed in operating environments between -20°C and + 40°C (-4°F and 104°F)

•No user serviceable parts inside. To avoid electric shock do not disassemble product.

•This product is not intended for use in emergency light xtures or exit signs.

ATTENTION:

Turn power o before inspection, installation, or removal.

Suitable for use in wet locations. Use only on 120VAC, 60Hz circuits.

DLF Surface Mount LED Downlight

INSTALLATION INSTRUCTIONS

Model:

DLF-10-120-#K-WH

Tools Needed

This LED Surface Mount Downlight requires very few tools for

installation. A screwdriver and a pair of wirecutters will help to

install the downlight to a J-Box or housing.

Make sure building wires are

accessible from J-Box.

Strip back wires minimum 3/8”.

Align screw holes (2) to J-Box and press

xture into box.

Remove faceplate from light by pulling up on

one edge until faceplate pops o.

4” Non-Metallic Ceiling Box Installation (20 in volume min)

Make sure all power is turned o before beginning installation

Splice xture wires to

the building wires with

push-in connectors

(included): black to line

(black), white to neutral

(white), and bare

copper wire to ground.

Carefully tuck wires

into J-Box.

Insert and tighten two (2) screws.

Re-attach faceplate to xture by

aligning faceplate with xture

and pressing until faceplate

clicks into place.

JBOX

LINE

Black (line)

Ground

White (neutral)

Black (line)

Green (ground)

White (neutral)

DLF

Power on the xtures to enjoy your new surface mount LED downlight.

Installation note: Alignment of lights requires that all J-Boxes are aligned and oriented with other J-Boxes in room.

Check xture alignment is consistent with others in room.

Summary of content (2 pages)

PAGE 1
DLF Surface Mount LED Downlight INSTALLATION INSTRUCTIONS Model: DLF-10-120-#K-WH WARNING: •Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing. •To prevent early lamp failure, lamp should only be installed in operating environments between -20°C and + 40°C (-4°F and 104°F) •No user serviceable parts inside. To avoid electric shock do not disassemble product. •This product is not intended for use in emergency light fixtures or exit signs.
PAGE 2
4” Octagonal (4/O) J-Box Installation Make sure all power is turned off before beginning installation 1 Installation note: Alignment of lights requires that all J-Boxes are aligned and oriented with other J-Boxes in room. 2 Make sure building wires are accessible from J-Box. Installation alignment of lights requires that all J-Boxes are consistently aligned with other J-Boxes in room. 3 Remove faceplate from light by pulling up on one edge until faceplate pops off. Strip back wires minimum 3/8”.