Installation Guide
What’s In The Box
One (1) DLS4
Three (3) Wire Nuts
One (1) Screw-in Edison Base
One (1) Pair of Friction Clips
ATTENTION:
Turn power o before inspection, installation, or removal.
Suitable for use in wet locations. Use only on 120VAC, 60Hz circuits.
NOTE: This luminaire has been modied and can no longer operate the originally intended lamp. The
provided label must be applied to the retrotted luminaire where visible during re-lamping.
DLS Surface Mount LED Downlight
INSTALLATION INSTRUCTIONS
Model(s):
DLS4-3006-120-#K-WH
Tools Needed
This LED Surface Mount LED Downlight requires very few
tools for installation. A screwdriver and a pair of wirecutters will
help to install the downlight to a JBox or housing.
Cut o xture connector and strip back wires minimum 3/8”.
1
Align screws (2) to JBox, mount DLS to Jbox by tightening screws.
3a
Make sure building wires are accessible from the JBox and splice
the xture wires to the building wires with wire nuts (included):
black to live (black), white to neutral (white), and green to ground.
2
Carefully tuck the wires into the J-Box.
2a
Standard 4” J-Box Installation
Make sure all power is turned o before beginning installation
Twist o DLS lens by twisting lens
counterclockwise.
3
Twist DLS lens back on by
twisting lens clockwise.
Power on the xtures to enjoy your
new surface mount LED downlight.
4
5
WARNING:
•Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing.
•To prevent early lamp failure, lamp should only be installed in operating environments between -20°C and + 40°C (104°F and -4°F)
•No user serviceable parts inside. To avoid electric shock do not disassemble product.
•This product is not intended for use in emergency light xtures or exit signs.