Installation Guide
What’s In The Box
One (1) DSK
Three (3) Wire Nuts Two (2) Mounting Screws
ATTENTION:
Turn power o before inspection, installation, or removal.
Suitable for use in wet locations. Use only on 120VAC, 60Hz circuits.
This xture will t in 4” Pancake Box, 4/O J-Box and Non-metallic 4” or 5” J-Box
DSK Surface Mount LED Downlight
INSTALLATION INSTRUCTIONS
Model(s): DSK4-1008-120-#K-WH
DSK56 -1010-120-#K-WH
Tools Needed
This LED Surface Mount LED Downlight requires very few
tools for installation. A screwdriver and a pair of wirecutters will
help to install the downlight to a J-Box or housing.
Identify location. The DSK can be
used for both new construction
and remodel installation. The DSK
is compatiable with 4” Pancake
Box, 4/O J-Box and non-metallic 4”
or 5” J-Box.
1
Make sure building wires are
accessible from the J-Box and splice
the xture wires to the building
wires with wire nuts (included):
black to line (black), white to neutral
(white), and green to ground.
Carefully tuck the wires into the J-Box.
2
Installation
Make sure all power is turned o before beginning installation
Remove DSK lens by twisting lens
counterclockwise.
3
Align screws (2) to J-Box, mount DSK
to Jbox by tightening screws.
3
Re-install DSK lens back on by
twisting lens clockwise.
Power on the xtures to enjoy your new surface mount LED downlight.
4
5
WARNING:
•Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing.
•To prevent early lamp failure, lamp should only be installed in operating environments between -20°C and + 40°C (-4°F and 104°F)
•No user serviceable parts inside. To avoid electric shock do not disassemble product.
•This product is not intended for use in emergency light xtures or exit signs.
JBOX
LINE
Black (line)
Ground
White (neutral)
Black (line)
Green (ground)
White (neutral)
DSK