Installation Guide

CAUTION
1. Read all instructions carefully for safe operation and installation
3. All wiring must be in accordance with national and local electrical codes. Installation work and electrical wiring must be done by
4. Do not install over a heat source and directly over water. Generally only for ventilating indoor use.
INSTALLATION
1. Remove all parts and hardware pack from carton (refer to Fig. A).
2. Insert connector (1) to the desired knockout (2) in housing (3).
Knockout is removed by pressing with screwdriver.
3. Open the top cover of the housing (3) . Connect the green wire (8)
with a metal close-loop ring at end to the housing (3) by securing the
close-loop ring in place between connector (1) and the housing (3).
using lock nut (4) provided (refer to Fig. B).
4. Insert supply wires (not provided) through connector (1) and
secure with the two screws (6) pre-installed on the connector (1).
DO NOT MIX! Use wire nuts (provided) to splice connections.
screws (5) provided (refer to Fig. C).
screw in the middle of housing. Please open the top cover and securely fasten the mounting screws.
6. Restore power and check installation
Note: Requires 120VAC/60Hz power supply for proper operation.
MAINTENANCE
CLEANING
WARNING! Never immerse electrical parts in liquid.
TROUBLESHOOTING
1. If light does not operate when the switch turns on, check that all wires are connected correctly. If it still cannot operate, call
manufacturer for service.
2. If leakage, a rattling or humming noise, unusual smell, smoke is found during the operation, please disconnect the power and
call the manufacturer.
3. Contact manufacturer for replacement lens.
LED Under Cabinet
Installation Instructions
Model(s): NUC-2-xx-xx
MAXCOR is a Trademark of NICOR, Inc.
NICOR, Inc. | 2200 Midtown Pl NE, Albuquerque, NM 87107 | P: 800.821.6283 | F: 800.892.8393 | www.nicorlighting.com
Complete warranty details can be found at http://nicorlighting.com/resources/warranty-info/led-under-cabinets