Installation Guide

LED Under Cabinet V4

INSTALLATION INSTRUCTIONS

NUC-4

CAUTION

1. Read all instructions carefully for safe operation and installation

2. To avoid possible electrical shock, shut off ele tricity before the installation.

3. All wiring must be in accordance with national and local electrical codes. Installation work and electrical

wiring must be done by a qualified ele trician

4. Do not install over a heat source or directly over water.

NICOR, Inc. | 2200 Midtown Place NE, Albuquerque, NM 87107 | 800.821.6283 | www.nicorlighting.com | rev08082016

Carefully unpack the Under Cabinet and hardware from its packaging.

Inspect product for defects due to shipping (refer to Fig. A).

Insert connector (1) in the desired knockout (2) in housing.

Open the top cover of the housing (3). Install the green wire with the

close-loop ring over the connector barrel (1) and secure to housing by

using the lock nut (4) provided.

Insert supply wires (not provided) through connector (1) and secure

with the two screws (6) pre-installed on the connector (1). Attach black

xture wire to black supply wire, white 

xture wire to white supply wire,

green xture grounding lead to grounding lead. DO NOT MIX! Use wire

nuts (provided) to splice connections.

Mount housing to desired surface with the two mounting screws (5)

provided (refer to Fig. C).

Note: For 40” xtures, there is an additional mounting screw hole in the middle of housing.

Open the top cover and securely fasten the mounting screw.

Restore power and check installation

Note: Requires 120VAC/60Hz power supply for proper operation.

Warranty

For complete warranty information please visit :

http://nicorlighting.com

FIGURE B

FIGURE C

FIGURE A

Note: Units are dimmable. If wired for dimming NICOR recommends using a

dimmer from the list below that has been tested for compatibility.

Lutron MACL-153M

Leviton IPL06

Leviton 6674

Lutron TGCL-153PH-WH

PAGE 1
LED Under Cabinet V4 INSTALLATION INSTRUCTIONS NUC-4 CAUTION 1. Read all instructions carefully for safe operation and installation 2. To avoid possible electrical shock, shut off ele tricity before the installation. 3. All wiring must be in accordance with national and local electrical codes. Installation work and electrical wiring must be done by a qualified ele trician 4. Do not install over a heat source or directly over water. 6 1 Carefully unpack the Under Cabinet and hardware from its packaging.