Installation Guide

ARCHITECTURAL LED TROFFER
INSTALLATION INSTRUCTIONS
The installation must only be performed by a licensed electrician.
To prevent death, injury or damage to property, this product must be installed in accordance to
National Electrical Code (NFPA70) in the US or Canadian Electrical Code (CSA 22.1) in Canada.
Disconnect power before installing the product or servicing it.
Wait until xture has cooled down before installing or servicing the xture.
MIN. 90°C SUPPLY CONDUCTORS
Carefully unpack the xture from its packaging.
Inspect product for defects due to shipping.
Locate desired positioning for the xture in ceiling grid.
Turn o power to appropriate circuit at the breaker box.
Place the xture into the T-bar ceiling panel. Secure to
structure and/or grid per state and local codes.
Remove cover from Power Supply/Junction Box by removing
two screws. NOTE: Make sure to remove cardboard padding
located between junction box and xture housing.
Connect wiring as shown. Grey and Purple wiring are for
0 - 10V dimming systems. Cap o individually if not used.
Reattach cover of Junction Box and secure with two screws.
Turn power on and verify that the panel is lit.
1
2
3
4
5
5
6
7
8
NICOR, Inc. | 2200 Midtown Place NE, Albuquerque, NM 87107 | 800.821.6283 | www.nicorlighting.com | September 22, 2015 3:04 PM
T3A-14-S-MV-35
T3A-22-S-MV-35
T3A-24-S-MV-35
T3A-14-S-MV-40
T3A-22-S-MV-40
T3A-24-S-MV-40
T3A-14-S-MV-50
T3A-22-S-MV-50
T3A-24-S-MV-50
MODELS:
Luminaire LED Driver
White
Black
Com
Line
GND
Junction Box
RedRed
BlackBlack
*
*Cap o if not used
*
Grey
Purple
1-10V (-)
1-10V (+)
6