Users Manual

ZW313S Dimmer Switch

SPECIFICATIONS

Model: ZW313S

Power: 120VAC, 60Hz

Signal (Frequency): 908.42 MHz

Maximum Load: 150W LED, 500W incandescent

(300 W with both sides of heat sink tabs oﬀ) Minimum Load: 5W for LED bulbs

Range: Up to 100 feet line of sight Operating Temperature Range: 32-104° F (0-40° C)

For indoor use.

Speciﬁcations subject to change without notice due to continuing product improvement

Approval: ETL/FCC/Z-Wave Plus Certiﬁed

FCC Caution.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the

user's authority to operate the equipment.

PAGE 1
ZW313S Dimmer Switch SPECIFICATIONS Model: ZW313S Power: 120VAC, 60Hz Signal (Frequency): 908.42 MHz Maximum Load: 150W LED, 500W incandescent (300 W with both sides of heat sink tabs oﬀ) Minimum Load: 5W for LED bulbs Range: Up to 100 feet line of sight Operating Temperature Range: 32-104° F (0-40° C) For indoor use. Specifications subject to change without notice due to continuing product improvement Approval: ETL/FCC/Z-Wave Plus Certified FCC Caution. This device complies with part 15 of the FCC Rules.
PAGE 2
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.