User's Manual

Equipment Manual: PPM 360 Meter Models DA118A
1050-1762 Revision A 10 Nielsen Confidential – Internal Use Only
5. Radio Frequency Exposure Information (SAR)
This equipment meets the U.S. government’s requirements for exposure to radio waves. The
exposure standard for wireless devices employs a unit of measurement known as the specific
absorption rate, or SAR. The SAR limit set by the FCC is 1.6 watts per kilogram (W/kg). Tests
for SAR are conducted using standard operating positions accepted by the FCC with the
device transmitting at its highest certified power level in all tested frequency bands. Although
the SAR is determined at the highest certified power level, the actual SAR level of the device
while operating can be well below the maximum value. This is because the device is
designed to operate at multiple power levels so as to use only the power required to reach
the network. In general, the closer you are to a wireless base-station antenna, the lower the
power output.
The highest measured SAR value for this device when worn on the body as described in this
user guide is 0.964 W/kg.
For SAR test,Body worn mode test distance is 5mm.Add
itional SAR
informatio
n for
this device can be retrieved by accessing the FCC Equipment Authorization search
page at http://www.fcc.gov/oet/ea/fccid/ and entering the following; FCC ID: IGKDA118A depending
on the specific device model.
The FCC ID for each device model is shown on the device equipment label.
For body worn operation, this device has been tested and meets the FCC RF exposure
guidelines when used with the belt-clip accessory provided by Nielsen Audio, Inc. Use of
other accessories may not ensure compliance with FCC RF exposure guidelines.
6. IC (Canadian Industry) Notice
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1.this device may not cause interference,
2.and this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
1.l'appareil ne doit pas produire de brouillage, et
2.l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
For SAR test,Body worn mode test distance is 5mm.
Pour les essais en mode portés à distance, est de 5 mm.
