Owner's manual

Instructions

Fits: PVS-7 | PVS-14 | LRM-14 | LRB-7

IPHONE NIGHT VISION CAMERA ADAPTOR

Thread on/off

MADE IN THE USA

1 2

Carefully remove rubber eyecup from the night vision device.

Unscrew the segmented ring from the retaining ring.

Place segmented ring around the eyepiece with threads facing up

follow with the retaining ring.

Once the Night Vision adaptor is attached to the optic thread it

onto iPhone Adaptor base - Use to locking ring if necessary

PAGE 1
IPHONE NIGHT VISION CAMERA ADAPTOR Fits: PVS-7 | PVS-14 | LRM-14 | LRB-7 Instructions Thread on/off 1 Carefully remove rubber eyecup from the night vision device. 2 Unscrew the segmented ring from the retaining ring. 3 Place segmented ring around the eyepiece with threads facing up follow with the retaining ring.
PAGE 2
IPHONE NIGHT VISION CAMERA ADAPTOR Fits: 740 | 750 | 760 Weapon Sights Instructions Thread on/off 1 To remove the rubber eyecup turn the diopter towards the left side of the scope so that it is fully extended out. 2 Ensure that the threads on the iPhone adaptor ring are clean and clear of debris. 4 Thread the eyepiece ring onto the iPhone adaptor base. Before fully tightening, position the adaptor at the desired angle and adjust the locking ring accordingly.
PAGE 3
IPHONE NIGHT VISION CAMERA ADAPTOR NIGHT OPTICS USA, INC 15182 Triton Lane, Suite 101 | Huntington Beach, CA 92649 Ph: (714) 899-4475 | Fax: (714) 899-4485 sales@nightoptics.com | info@nightoptics.