Installation Manual

5
Connect the two included antennas
to your wireless NVR. This will
ensure you achieve the maximum
wireless range for transmission
from your wireless cameras.
1
Plug the other end of the
HDMI cable into the back of
your TV or monitor.
3
Plug one end of the included
HDMI cable into the HDMI port
on the back of the Wireless NVR.
2
Plug one end of the included
Ethernet cable into the LAN port
on the back of the Wireless NVR.
4
Plug the other end of the
Ethernet cable into a port on
the back of your router.
5
Plug the USB mouse into the
USB port on the back of the NVR.
6
HDMI
ETHERNET
HDMI
You may also connect using VGA (not included)
(Router Not Included)
ETHERNET
NOTE: Monitor is required for initial setup.
To view cameras, TV/Monitor must be tuned
to the same Input the HDMI is plugged into.
Connecting Your System