User Guide

To CAMERA
To CAMERA
Bullet
Camera(s)
Dome
Camera(s)
Video / Power Cable(s)
(1 per camera)
Camera Power
Adapter(s)
(1 per 4 cameras)
Power Splitter(s)
(1 per 4 cameras)
Mounting Hardware
(1 packet per camera)
Power
Drill
STOP: BEFORE installing, test
each camera locally to conrm
they function properly.
Using the holes in the mounting base or the camera’s mounting bracket ,
mark your screw positions on the surface where you plan to mount the camera.
FOR DOME CAMERA: If your cable is being run through a wall / ceiling, insert
the cable through the center ring of the mounting base before mounting.
Cable not being run through a wall / ceiling? Use the cut out .
FOR DOME CAMERA: Make sure screws are securely fastened. Attach the
dome camera to the mounting base, if not already pre-installed.
Using a drill bit slightly smaller than the included screw anchors, drill into the
mounting surface using the guide marks. Insert the screw anchors. Line up the
camera base holes with the screw anchors. Holding the mounting base or
mounting bracket in place. Insert screws and tighten until secure.
Quick Setup Guide
Before you get started, you will need:
Connecting Your Cameras
Mounting Your Cameras
Connect the end of the
camera’s cable to the end of
a video / power cable labeled
TO CAMERA ONLY.
Connect the video / power
cable labeled TO DVR ONLY to
an open video input on the
back of the DVR.
Connect the red female power
leads of the video / power
cables to the male power
splitter ends.
Connect the power splitter to
the camera power adapter and
plug it into a surge protector or
Uninterruptible Power Supply
(UPS).
DISCLAIMER: The exact components of your product, images, and quantities may vary depending on your model number.
www.NightOwlSP.com
DISCLAIMER: You must have an open video input on the DVR to connect a new camera.
NOTE: Audio enabled cameras
have a white RCA connector to
transmit audio signal (Optional).
NOTE: Make sure you twist
and lock BNC connectors.
A
A
A
A
A
B
B
B
BB
B
*
Mounting base may not be pre-installed
depending on your model #.
If your cable is not being run through a wall / ceiling, use the cut out on the mounting base / bracket.
To CAMERA
VIDEO / POWER CABLE
POWER SPLITTER
CONNECTORS
CAMERA POWER
ADAPTER
POWER
SPLITTER
FROM CAMERA
AUDIO CABLERCA CONNECTOR
POWER CABLE
CONNECTORS
SURGE PROTECTOR
(NOT INCLUDED)
2
2
1
1
Adding a Wired Camera to the DVR
Cameras / Accessories
1
1
3
2
4
2 3 4
Item Not Included
NOTE: For optimal recording, mount the camera at least
7 ft. above the ground and angle it slightly down.
Dome Camera(s)
*