Full Product Manual

17Chapter 4: Camera Installation
4.2 Mounting the Cameras
Camera distance from NVR.
Your wireless IP cameras will reach up
to 300 ft. wirelessly. Therefore, proper
placement of the wireless NVR in your
home will help ensure you achieve
maximum coverage.
Do not place near high voltage wires or
other sources of electrical interference.
Electrical interference will degrade the quality of the signal.
Place camera out of reach to avoid vandalism.
Avoid direct exposure to weather. Do not place the camera where rain or snow will
hit the lens directly nor should the camera be placed so that the sun or bright
light shines directly into the lens. Your camera is weatherproof, but it will not work
when submerged in water. Ensure that all power and video connections are not
directly exposed to water and are protected from the elements.
Mounting surface. The mounting surface must hold at least four times the
camera’s total weight.
1. Locate a camera and choose a location where you would like to mount
the camera.
2. Indicate screw positions by marking three holes on the surface where you plan
to mount the camera, using the holes in the camera base as a guide.
3. Using a drill bit slightly smaller than the included screw anchors, drill into the
mounting surface using the guide marks you placed in the previous step.
4. Insert the screw anchors.
5. Line up the camera base holes with the screw anchors. Holding the base in
place, insert screws and tighten until secure.
Connect all cameras locally before final placement
to ensure that all components function properly.