User Manual

2. INSTALLATION/PREPARATION
2.4 Operator's Manual WEE-1000
Installing the Access point
WARNING
• When attaching the access point to a wall or rack, you must have a
qualified builder attach the access point. Show the builder this
manual.
• Attach the access point securely enough to withstand external force
or vibration caused by an earthquake.
• Tell the builder the size and weight of the access point. Both size
and weight of the access point affect safety.
Dimensions and weight: 240 (W)
××
××
× 55 (D)
××
××
× 200 (H) mm, 1.5 kg
(without antenna).
• Do not install the access point near a microwave oven. The
microwaves from the microwave oven may interfere with the radio
wave communication between the telemetry unit and access point.
CAUTION
• Use the provided ZR adapter when installing the access point.
Otherwise, the access point may fall off and cause injury.
• Use appropriate screws according to the material and structure of
the wall or rack.
• Make sure that there is enough space between the access point and
the wall for adequate ventilation. Leave more than 1 cm of space
between the wall and vent holes on the rear panel of the access
point. Otherwise the internal temperature of the access point rises,
which leads to inaccurate operation and shortens the access point
life.
• Install the access point at least 20 cm away from the operator.
• Do not install the telemetry unit and access point in a place where is
blocked by metal or concrete, or do not install the access point with
its antenna bent. Decreased radio wave causes frequent signal loss
between the telemetry unit and access point.
• Do not install the access point and telemetry unit near a device
which uses Bluetooth® wireless technology or wireless LAN device
which complies with IEEE 802.11b near the wireless input unit at the
same time. If they are used together, the radio waves interfere with
each other. This may prevent the communication between the
telemetry unit and access point by reducing transmission speed and
transmission distance.
• Do not give impact to the antenna. This may damage the access
point or cause access point malfunction.
NOTE
Select a place where the POWER lamp, TX lamp and RX lamp can be
checked.