User Manual

2. INSTALLATION/PREPARATION
2.10 Operator's Manual WEE-1000
CAUTION
• Battery replacement should only be done by the operator. During
measurement, when replacing the battery, be careful not to touch the
patient.
• Do not charge a deteriorated battery. Otherwise, the instrument
cannot operate on battery power.
• Before turning the telemetry unit on, make sure that the battery
holder is firmly attached to the telemetry unit. If any static electricity
enters the telemetry unit, it may cause malfunction.
• When the telemetry unit is not used, remove the battery from the
telemetry unit.
• When replacing the battery, while the telemetry unit is connected to
the access point with the isolator, do not touch the metal part of the
connector. Otherwise the telemetry unit may malfunction due to
electrostatic energy.
• Before disposing of the battery, check with your local solid waste
officials for details in your area for recycling options or proper
disposal. The battery is recyclable. At the end of its useful life, under
various state and local laws, it may be illegal to dispose of this
battery into the municipal waste stream.
NOTE
Use a fully charged lithium-ion rechargeable battery, a new 006P 9V
lithium battery or new 006P 9V alkaline battery for every
measurement.