User Manual

3. EEG/PSG MEASUREMENT
3.22 Operator's Manual WEE-1000
Changing the Measurement Settings
Before starting measurement, check and change the following system settings in
the System Program. The changed settings are saved in memory. The Acquisition
program and the Review program use these settings.
• Electrode junction box setting (Select the JE-011A, JE-012A or JE-013A)
• Pattern settings
• AC line frequency setting
• Contents of the table list of the Patient Information
• Contents of the Annotation dialog box when annotating waveforms or adding
annotations.
• The electrodes that are used for waveform acquisition and saved in a file with the
EEG waveforms
You can save the changed system settings in a file. Each electrode junction box has
its own system settings for the above settings other than the AC line frequency. For
example, when the system settings which use the JE-011A electrode junction box
are saved in a file, next time you can select the JE-011A electrode junction box by
calling up a system settings file which uses the JE-011A electrode junction box.
Refer to “Changing the System Settings” in Section 2. For detailed information
about the system settings, refer to the operator’s manual of each
electroencephalograph.
NOTE
• It is not possible to change System Program settings while the
Acquisition, Review or any other EEG application program is open.
• Before selecting another electrode junction box in the Electrode
Junction Box menu, save the current system settings in a file.
Otherwise, the current system settings listed above are lost.